LD-7L Locator Quick Start Guide

Read these instructions carefully before installing the Quuppa LD-7L. Please also read the Quuppa LD-7L Installation Guide and watch the Mounting LD-7L Outdoor Training Video.

LD-7L Locator

  1. Ethernet socket - Waterproof only if used with a waterproof connector
  2. Type label
  3. Vent plug- DO NOT OPEN
  4. "HANDLE WITH CARE" sticker
    Warning: Do not attempt to open the device or remove the vent plugs, this will permanently damage the device.

Mounting Quuppa LD-7L

  1. Attach the Quuppa LD-7L to compatible VESA 200x200 mounting bracket. Use M6 bolts and assembly torque of 2 Nm (max allowed torque is 2.5 Nm).
  2. Attach the VESA mounting bracket to the wall, ceiling, or mast. Make sure that the LD-7L is installed the right way up with the drip shield at the top (highlighted in the picture).

  3. Aim the Quuppa LD-7L towards the intended coverage area and tighten all fasteners.
  4. Connect the Ethernet cable with a waterproof Ethernet connector to the Quuppa LD-7L. Make sure the other end of the cable is connected to a device connected to the Quuppa system.
    Warning: Always make sure that the installation surface or mast can carry the weight of the equipment and possible wind loads as well as keep the device stable in case of shakes or vibrations before installation. Not following general safety regulations can cause damage to property or bodily injuries. Rely on qualified personnel for carrying out the installation of Quuppa LD-7L. Quuppa disclaims any and all liability, losses and damages caused by or resulted from wrongful installation or mounting of the Quuppa system or any devices or products connected thereto.

Installation Tips

  • Install the device tilted to allow rainwater to run off the device.
  • Install a cover over the device to stop rain, snow or dust from getting into the device.
  • Use Ethernet cables and connectors designed for outdoor use, even in indoor installations, to prevent water, moisture and dust from getting into the device. The Ethernet socket of the Quuppa LD-7L is Conec 17-10020 and it accepts both bayonet and M28 threaded waterproof Ethernet connectors from Conec, for example 17-100464.

  • Always make sure that no water (i.e. moisture) gets inside the Ethernet socket during or after the installation. Apply a drip loop to the cable to prevent water from entering the device.

Warning: The warranty remains valid only if the Quuppa LD-7L is mounted, installed and used correctly.

Recycling and Disposal

Always return your used electronic products, batteries, and packaging materials to dedicated collection points. This way you help prevent uncontrolled waste disposal and promote the recycling of materials.

Disposal of Electrical and Electronic Equipment. This crossed-out wheeled-bin symbol indicates that this product should not be treated as household waste. Instead hand it over to the appropriate collection point for the recycling of electrical and electronic equipment in accordance with local environmental regulations for waste disposal.

Ensuring proper product and battery disposal prevents potential negative consequences for the environment and human health. For more information, contact your city, the place of purchase, or [email protected]

Declaration of Conformity

Hereby, Quuppa Oy declares that this Quuppa LD-7L product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. A copy of the Declaration of Conformity can be found at:

https://quuppa.com/product-documentation/manuals/q/megamap/topics/hardware_declaration_of_conformity.html

© 2020 Quuppa. All rights reserved.